Network Edge Cloud Connectivity - Edit resource

In this guide, we will walk you through the steps to modify a cloud connector in designed status.

From the Inventory, select the cloud connector

Note

Only a cloud connector in Designed status can be modified.

Select the cloud connector in the inventory and click on the tree dots on the right and click on Edit resource:

Step 1 : Project

Note

You can't change the project attached to a cloud connector.

You have to create a new cloud connector with the corresponding project.

Step 2 : Essentials settings

Note

The journey is quite the same as the creation one, except for the flavor option which can’t be changed.

The name and the Equinix credentials can be changed on this screen.

You can also modify the following technical parameters :

Parameter	Description
A Side Virtual Device Id Primary	Fill with the Device Id Primary of your network edge.
A Side Interface Id Primary	Fill with the Interface Id Primary of your network edge.
A Side Virtual Device Id Secondary	Fill with the Device Id Secondary of your network edge.
A Side Interface Id Secondary	Fill with the Interface Id Secondary of your network edge.

Note

If you've defined only one network edge instance, you need to set the same UUID for the fields : A Side Virtual Device Id Primary and A Side Virtual Device Id Secondary. In than case you have to use and define different "A Side Interface Id Primary" and "A Side Interface Id Secondary".

Click on Continue button.

Step 3 : General service parameters

On this screen you can modify the following parameters :

• Location
• Reserved Bandwidth
• Configured Bandwidth
• Technical VPN

Note

Location represents where Orange Business network and Equinix network are directly connected.

Click on Continue button.

Step 4 : Connectivity parameters

On this screen you can modify the following parameters :

Parameter	Description
A Side Bgp Asn	Define the Asn you want to implement on your network edge for bgp routing.
IP Subnet Primary	Define /30 subnet you want to configure on the primary link with your network edge (CIDR notation).
IP Subnet Secondary	Define /30 subnet you want to configure on the secondary link with your network edge (CIDR notation).
Routing policy	Basic aggregate: only RFC1918 aggregate will be sent to Equinix. Default route: Only a default route will be sent to Equinix. No aggregate: All your VPN IP routes will be sent to Equinix (Could cause a routing table overflow)

Apply the requested changes and click on Continue when it's ok.

Step 5 : Summary and pricing

On this screen you have on the right a summary and an estimated pricing for this configured cloud connector.

From this page you have multiple possibilities :

Option	Description
Modification	Click on the Modify button of the section where you want to modify parameter or click on Back button to navigate to previous pages.
Cancellation	Click on the Cancel button.
Designing	Click on the Save as designed button if you want to save your new configuration. You will be able to provision last the cloud connector from Cloud Connector Inventory. See Provision.